Boo-tiful Halloween Pillows | Part 5 | Finishing Touches!

Hello and welcome to the wrap-up post for my Boo-tiful Crochet Halloween Pillow CAL; I hope you had as much fun as I did crafting this spooky duo as I did!This post contains affiliate links; if you click & make a purchase, I receive a small commission that I use to help support my family and the operation of this site at no additional cost to you. Thanks! Read my full disclosure policy.

Boo-tiful Crochet Halloween Pillow | Part 5

Hello and welcome to the wrap-up post for my Boo-tiful Crochet Halloween Pillow CAL; I hope you had as much fun as I did crafting this spooky duo as I did!  New to the CAL? Not to worry, you can check the previous posts with graphs, word charts and instructions here: Part One, Part Two, Part Three, and Part Four.

Supplies:

1. Worsted Weight Yarn in the color of your choice, or snag the yarn I used here.

2. Yarn Needle

3. Scissors

4. Pillow Form (Mine was 12 inches by 12 inches).

5. Two completed crochet panels.

Step 1:

Measure your completed panel and buy the correct size pillow form.  For my pillows, I used a 12-inch by 12-inch pillow form. Once you have your panels and pillow, it’s a good idea to check fit before you start stitching the edges.

My tension and gauge tend to run tight, so after completing my SC edge; I opted to add an additional round of HDC as pictured below.

Step 2:

Next, you will stitch your edges along three sides; you can use slip stitch, single crochet or sew them together with a yarn needle as pictured below.

Step 3:

Insert your Pillow Form, and sew the final edge shut.

Step 4:

Tie off and weave in your ends!

Wrapping up this spooky project is quick and easy; which is a bonus since Halloween is just around the corner! But feel free to reach out if you run into issues or have questions by leaving me a comment below. Happy Hooking!